whats is the emergency recovery code smart switch

Step 2 – Repair the SQL Database Manuallyīefore starting the repair procedure, it’s important to switch the database to SINGLE_USER mode to prevent other users from using the database. This command will return the state of the database ‘Test_Database’.Īs you can see the ‘Test_Database’ is in EMERGENCY state. Step 1 – Check the Database Stateīefore proceeding, check if the database is still in EMERGENCY mode by running the following command: SELECT name, state_desc FROM sys.databases WHERE name = Test_Database How to Recover SQL Database from Emergency Mode to Normal Mode?įollow these steps to manually repair a SQL database and restore it to normal mode. If the database is still in an EMERGENCY state, you will need to manually repair your database. In that case, you cannot access the database information unless you bring it back to its normal state. Note: if your database goes into SUSPECT state due to corruption, setting it to ONLINE state will just return a database in SUSPECT status. But, if the database seems stuck in EMERGENCY mode, try to bring it ONLINE by executing this command: ALTER DATABASE database_name SET ONLINE Since the database is under repair, it might take you a few minutes to bring the database back online. Setting a database in EMERGENCY mode helps access the database and run a repair on it using DBCC CHECKDB with REPAIR_ALLOW_DATA_LOSS command. Essentially, when a database status is changed to SUSPECT, it becomes inaccessible. The EMERGENCY mode is a read-only status used to read data from databases in the RECOVERY PENDING/SUSPECT mode.

Whats is the emergency recovery code smart switch